| 5. Take the circle piece
and make 2 holes through yhe card, 10mm apart, as
close to the wire as possible. Make another 2
holes inbetween these, equal distances apart.
Push the ends of the smallest piece of wire
through the middle holes as shown. 6. Take the longest piece
of wire and push this through the outer holes.
You may need to fiddle about with the wires to
get the back of the chair even. When your happy
with it, put a drop of glue at the top of the
chair where the 2 wires meet and a few drops of
glue under the seat to hold the wires in place.
7. Take the last
piece of wire and glue under the seat at the
front edge. Adjust the legs and trim so the chair
isn't wobbly.
8. Paint the
chair. I sprayed with a coat of black matt before
I sprayed the gloss as I found the black gloss
would not dry on the plastic coated wire (test a
small piece of wire first).
For the chair
seat I simpy cut a circle of fabric, glued to the
chair and trimmed with some small braid.
|
